Geotab User Guide
Repositioning the OBDII Port
Moving the port or using an extension cable
Repositioning the OBDII Port
If you decide that the unit sticks out too much, then you could consider making a small adjustment, which is very easy for you to do. Keep in mind that some drivers may not want to be tracked. If the tracking unit is sticking out, then a driver may “accidentally” kick the unit, in order to disable it.
Unscrew the OBDII port, turn it 90°, and tie it back into the vehicle with a simple twist tie. Every OBDII port is connected to the body of the vehicle with either two screws, one single screw, or no screws at all – ie. it pops in/out of the frame.
If you decide that you do not want to make this small adjustment, then you can purchase a harness to extend the reach of the Geotab GO device (Extension Cable) or a T-harness which will allow an additional OBDII port to remain available.
